Operation CHARM: Car repair manuals for everyone.

Suspension Control Module: Testing and Inspection






Control Position, Programming with Vehicle Diagnosis Tester

Adapting control position and checking headlamp basic setting is necessary if:

The lower transverse link has been removed and reinstalled or replaced.

The subframe was replaced.

Installation work has been performed on the level control system sensor.

The level control system sensor has been replaced.

The level control system sensor coupling rod threaded connection was loosened at the lower transverse link.

The level control system control module (J197) was replaced.

Requirements

The vehicle must be standing on an even surface.

The vehicle may not be loaded.

- Connect the vehicle diagnosis tester and select address "34 - level control system control module" in "Guided Functions".

Then

- Select "J197 - reprogram control position" and follow the instructions on the screen.

If the control position was reprogrammed and if the vehicle has lane assist, then it will be necessary to calibrate the camera control module (J852). Refer to => [ Camera Control Module (J852), Lane Assist, Calibrating ] Testing and Inspection.