Rear Glass Panel

Rear Glass Panel

Removing

- Open the front glass panel all the way.

- Remove the screws - 1 - from the rear glass panel - 3 -.





- Remove the spacer - 2 - between the glass panel - 1 - and the frame - 4 -.

- Open the front glass panel.

- Gently pull the inner seal - 3 - inward at the marked locations - arrow - and remove the screws - 2 -.





- Lift out the rear glass panel - 1 -.

Installation

Installation is the reverse of removal.

• Replace the screws when installing or removing the glass panel.

- Install the glass panel from the top into the roof.

- Gently pull the inner seal - 3 - inward at the marked locations - arrow - and install the screws - 2 -, but do not tighten them.





- Adjust the rear glass panel. Refer to => [ Front and Rear Glass Panel Height, Adjusting ] Adjustments

- After the rear glass panel is adjusted, tighten the screws to 5 Nm.

- After completing this procedure, perform an adaptation on the sunroof motor. Refer to => [ Sunroof Adaptation ] Testing and Inspection.