Crankshaft Overview

Crankshaft Overview

• Secure the engine to the assembly stand using the engine and transmission holder (VAS 6095) whenever performing any repairs. Refer to => [ Engine, Securing to Engine and Transmission Holder ] Procedures.






1 Cylinder Block

2 Bearing Shell for Cylinder Block

• With lubricating groove

• Do not interchange used bearing shells (mark)

• Crankshaft bearing shells identification (classification) => [ Crankshaft Bearing Shells, Allocating ] Crankshaft Bearing Shells, Allocating

3 Crankshaft

• After removal, place in such a way it does not rest on sensor wheel - 5 - and damage it

• Axial clearance, refer to => [ Axial Clearance, Measuring ] Testing and Inspection

• Radial clearance, refer to => [ Radial Clearance, Measuring ] Testing and Inspection

• Do not turn crankshaft when measuring radial play

• Crankshaft dimensions, refer to => [ Crankshaft Dimensions ] [1][2]Crankshaft, Engine

4 Bearing Shell for Bearing Cap

• Without lubricating groove

• Do not interchange used bearing shells (mark)

• Crankshaft bearing shells identification (classification), refer to => [ Crankshaft Bearing Shells, Allocating ] Crankshaft Bearing Shells, Allocating

5 Bolt

• Replace

• Tightening order => [ Crankshaft, Tightening Sequence ]

6 Bearing Cap

• Bearing cap 1: belt pulley side

• Retaining tabs of bearing shells and cylinder block/bearing caps must lie above one another

7 Bolt

• Replace

• 10 Nm plus an additional 90° turn

• Replace sensor wheel every time bolts are loosened, refer to => [ Sensor Wheel ] Service and Repair

8 Sensor Wheel

• For the engine speed sensor (G28)

• Only possible to install in one position - Bores are offset

• Replace sensor wheel every time bolts are loosened

• Removing and installing, refer to => [ Sensor Wheel ] Service and Repair

9 Thrust Washers

• For bearing 3

10 Bolt

• Replace

• Tightening order => [ Crankshaft, Tightening Sequence ]

Crankshaft, Tightening Sequence





- Tighten the crankshaft bolts in the sequence - 1 to 5 -.

- Tighten the bolts - 1 through 10 - and - arrows - hand-tight.

- Tighten the bolts - 1 through 10 - to 65 Nm.

- Tighten the bolts - 1 through 10 - 90° further using a rigid wrench.

- Tighten the bolts - arrows - to 20 Nm.

- Tighten the bolts - arrows - 90° further using a rigid wrench.