Rear Outer Belt Anchor

Rear Outer Belt Anchor

• Removal and installation are same for right and left.

Removing






- Remove the rear seat. Refer to => [ Seat Frame ] Seat Frame.

- Remove the rear sill trim. Refer to => [ Rear Sill Panel Trim ] Rear Sill Panel Trim.

- Remove the bolt - 1 - and remove the belt end fitting - 2 -.

Installation

Installation is reverse of removal, but note the following:

- If parts of the seat belt system are removed due to an accident, replace the belt system mounting bolts.

• To position the belt end fitting properly, the opening that is on the bolting surface for this fitting must be positioned on top of the pin that is on the floor panel.

Tightening specifications, refer to => [ Rear Outer Three-Point Seat Belt Overview ] Rear Outer Three-Point Seat Belt Overview.