Fuse Panel D with Right Instrument Panel Fuse Panel

Fuse Panel D with Right Instrument Panel Fuse Panel

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

Removing






- Switch off ignition and remove ignition key.

- Disconnect the battery ground (GND) cable from the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove glove compartment.

- Pry the instrument panel side cover off with the (3409) in the direction of the - arrow - and remove it.

- Remove the instrument panel CAN cut-off connector (T46s) mount - 4 -. Refer to => [ Instrument Panel CAN Cut-Off Connector (T46s) Mount ] Instrument Panel CAN Cut-Off Connector (T46s) Mount.






- Release retaining clips - 1 - in the direction of the - arrow - and press the fuse panels - 2 - and - 3 - back and out of the fuse panel D (SD).

- Release the retaining clips - A arrow - and tilt the fuse panel D - 2 - in the direction of the - B arrow - on the instrument panel central tube - 1 -.






Installing

Install in reverse order of removal, observing the following:

- Install the instrument panel CAN cut-off connector mount. Refer to => [ Instrument Panel CAN Cut-Off Connector (T46s) Mount ] Instrument Panel CAN Cut-Off Connector (T46s) Mount.

- Install glove compartment.

- Connect battery. Required actions, refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.