Operation CHARM: Car repair manuals for everyone.

Right Engine Mount






Right Engine Mount

To avoid repeat repairs, do the following if the engine mount is faulty:

Replace the faulty engine mount and its retaining plate.

Likewise replace the engine mount on the opposite side, check the retaining plate and replace it if necessary.

Special tools, testers and auxiliary items required

Engine Support Bridge (10 - 222 A)

Spindle (10 - 222 A /11)

Removing

- Remove the rear engine cover - top arrows -.






- Position the (10 - 222 A) on the left and right suspension strut tower as shown in the illustration.






- Engage the (10 - 222 A /11) on the right engine lifting eye and tension it slightly.

- Remove the right front wheel.

- Remove the right front wheel housing liner..

- Remove the noise insulation - 1 and 2 -..






- Remove the nut - 1 - and remove the bracket with the wiring harness from the subframe.






- Remove the bolts - 1, 2 and 4 - and move the right engine mount retaining plate - 3 - to the side.






- Remove the bolt - arrow - on the ATF line bracket.






- Raise the engine by dimension - a - using the (10 - 222 A /11).






Dimension - a - = approximately 20 mm.

- Remove the right engine mount.

Installing

For the correct tightening specifications, refer to => [ Subframe Mount Overview ] Subframe Mount Overview.

Install in reverse order, paying attention to the following:

- Install the ATF lines.

- Install the wheel housing liner and noise insulation..

- Mount the front wheel.