Power Take-Off Drive Chain

Power Take-Off Drive Chain

Special tools, testers and auxiliary items required

• Locking Pin (T40071)

Removing






• The transmission is removed.

- Remove timing chain lower cover => [ Lower Timing Chain Cover ] Lower Timing Chain Cover.


Risk of destroying due to reversed running direction on a used drive chain.

• Paint arrows to mark the power take-off drive chain running direction so it can be installed again.

- Press the tensioning rail in the direction of the - arrow - and secure it with a (T40071).

- Remove the bolt - 1 - and remove the idler sprocket.

• Pay attention to the compression spring when removing => [ (Item 4) Pressure Spring ] Power Take-Off Drive Chain Overview.

- Remove the bolts - 2, 3 and 4 - and the chain tensioner.

- Remove the power take-off drive chain.

Installing

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to => [ Power Take-Off Drive Chain Overview ] Power Take-Off Drive Chain Overview.

• Replace the gasket.

• Secure all hose connections with hose clamps of the same type as those equipped by the factory, refer to the Electronic Parts Catalog (ETKA)

- Install timing chain lower cover. Refer to => [ Lower Timing Chain Cover ] Lower Timing Chain Cover.