Intake Manifold: Service and Repair
Remove and Install1. Disconnect the air bellows from the throttle valve.
2. Disconnect the electrical connector at the air flow meter.
3. Unscrew the carbon canister hose mounting at the air flow meter.
4. Disconnect the upper section of the air cleaner and remove together with the air flow meter and bellows.
Throttle Valve Location:
5. Remove the throttle valve.
Manifold Support Location:
6. Unscrew front manifold support.
Vacuum Booster Hose:
7. Remove vacuum hose at brake booster.
Rear Manifold Support Location:
8. Unscrew rear manifold support.
9. Remove idle control valve.
Upper Manifold Bolts:
10. Unscrew screws and remove upper manifold section.
Upper Manifold Removal:
11. Lift upper manifold section until stud (2) has cleared, then turn to the left and lift off.
Electrical Conduit Connector:
12. Pull electrical conduit plate from injectors.
Hose Connection Location:
13. Disconnect fuel feed and return pipes.
14. Remove screws and pull injection rail together with fuel injectors out.
15. Lift retainer out and pull fuel injectors off.
16 Remove lower section of intake manifold.
17. Reinstall in reverse manner.
Manifold Dowel Location:
NOTE: Check for correct seating of dowel sleeves (3 and 4), use new gaskets.