Removing and Installing/Replacing Oil Sump Bottom Section (N73)

11 13 020 - Removing and installing/replacing oil sump bottom section (N73)





Necessary preliminary tasks:
- Remove reinforcement plate Service and Repair.
- Open oil drain plug Service and Repair and drain off engine oil.





Disconnect plug connection on oil level sensor (1).
Release screws (2) and remove oil level sensor (1).
Release screws along line (3) and remove oil sump (4).

Installation:
Tightening torque, 11 13 2AZ [1][2]11 13 Oil Pan.
Clean sealing surfaces.
Replace gasket and sealing rings.





Assemble engine.