Valve Spring: Service and Repair
11 34 715 - Replacing all valve springs (M52/S52/M52TU/M54/M56)
Special tools required:
- 11 0 342
- 11 0 345
- 11 1 045
- 11 1 065
- 11 1 441
- 11 3 030 11 3 030 Placement Board for Tappet
- 11 3 250 11 3 250 Suction Cup
(cylinder head removed)
Preliminary tasks are described in Disassembling and assembling cylinder head Disassembling and Assembling Cylinder Head (M52/S52/M52TU/M54/M56).
Brace bucket tappets with special tool 11 3 250 11 3 250 Suction Cup.
Lift out bearing strip with bucket tappet.
Installation:
Only re-use used bucket tappets in the same tappet bore.
Arrange bucket tappets by cylinder and place on special tool 11 3 030 11 3 030 Placement Board for Tappet in correct order.
Insert special tool 11 1 441 from below in special tool 11 1 065 and secure with special tool 11 1 045.
Align special tool 11 0 345 in direction of valve shaft and select appropriate groove in special tool 11 0 342.
Press down valve spring on spring cap, top, and remove valve keys.
Remove valve spring and plate spring.
Arrangement:
1) - Valve
2) - Valve-stem seal
3) - Lower plate spring
4) - Valve spring
5) - Top plate spring
6) - Valve tapers