Securing Engine In Installation Position (M54)

11 00 670 - Securing engine in installation position (M54)





Special tools required:
- 00 0 200 00 0 200 Cross Member
- 00 0 202 00 0 200 Cross Member
- 00 0 204 00 0 200 Cross Member
- 00 0 208 00 0 200 Cross Member
- 11 0 020 11 0 020 Engine Hoist for Removing and Installing Engines





Warning!
Danger of injury!

Observe following instructions relating to special tool:

1. Prior to each use, check the special tools for defects, modifications and operational reliability.
2. Damaged/modified special tools must not be used!
3. No changes or modifications may be made to the special tools!
4. Keep special tools dry, clean and free of grease.





Necessary preliminary tasks:
- Secure engine bonnet/hood in service position Procedures
- Remove intake filter housing Service and Repair
- Remove cover for windscreen cowl panel. 51 13 115 Removing And Installing/Replacing Cowl Panel Cover
- Remove tension strut on spring strut dome Service and Repair
- Remove microfilter housing
- Remove acoustic cover





Assemble cross member 00 0 200 00 0 200 Cross Member with special tools 00 0 202 00 0 200 Cross Member, 00 0 204 00 0 200 Cross Member, 00 0 208 00 0 200 Cross Member.





Important!
Avoid a change of engine position in the transverse or longitudinal direction.

Always make sure there is sufficient clearance between the engine (or its attachment parts) and the body.





Important!
Risk of damage!

With the aid of an assistant and the supports, place cross member 00 0 200 00 0 200 Cross Member on the screw connections of the side panels.

Secure special tool 11 0 020 11 0 020 Engine Hoist for Removing and Installing Engines to spindle 00 0 202 00 0 200 Cross Member.

Fit suitable chains to special tool 11 0 020 11 0 020 Engine Hoist for Removing and Installing Engines and attach to both engine lifting eyes (1).





Warning!
Danger of injury!

Tighten down all adjusting screws and nuts on cross member 00 0 200 00 0 200 Cross Member.





Unscrew nuts (1).

Raise engine approx. 10 mm with cross member.

Installation Note:
Replace self-locking nuts.

Tightening torque 22 11 2AZ Specifications.