51 16 200 Removing and Installing Storage Compartment

51 16 200 - Removing and installing storage compartment





Special tools required:
- 00 9 323






Necessary preliminary tasks:
- Remove trim for storage tray 51 16 212 Removing and Installing Trim for Storage Compartment





Lever out covers (1) and release screws underneath.






Important!
Carefully unclip catches (2) on trim (1) (risk of damage).

Move with special tool 00 9 323 from below behind trim (1) and release catches (2).

Release trim (1) towards rear from catches (3).
If necessary, disconnect plug connections and remove trim (1).






Installation:
Catches (1 and 3) must not be damaged.
Guides (2) must not be damaged.





Unscrew nuts (1).
Depending on equipment specification:
If necessary, disconnect cable strap (2) and plug connections (3 and 4).





Pull off gaiter (1) towards top.
Specification with telephone:
Detach plug connection (2) from holder and disconnect plug connection (2).





Raise storage compartment (2) at rear and feed out gaiter (1) through opening.
If necessary, disconnect further plug connections and feed out cable.
Remove storage compartment (2) towards rear/top.






Installation:
Guide (1) of storage compartment (2) must be fed behind panel (4) on left/right.
Specification with ventilated multifunction storage:

Air duct (3) must be correctly inserted in storage compartment (2).