Removing and Installing/Replacing Left B-Pillar Sensor

65 77 720 - Removing and installing (replacing) left B-pillar sensor





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Warning!
Note airbag safety instructions [1][2]Safety Regulations for Handling Components with Gas Generators!
Incorrect handling can activate airbag and cause injury.





Necessary preliminary tasks:
- Remove luggage compartment floor trim 51 47 101 Removing and Installing/Replacing Luggage Compartment Floor Trim Panel
- Disconnect battery negative lead Instructions for Disconnecting and Connecting Battery and cover
- Remove trim panel for door pillar Removing and Installing/Replacing Trim for Left or Right Door Pillar (Bottom) (bottom)





Release screw (1).
Loosen screw (2).

Installation Note:
Tightening torque 65 77 5AZ Airbag Triggering Control.

Raise B-pillar sensor (3) slightly through opening in B-pillar and feed out towards rear.

Unfasten plug connection (4) and disconnect.
Remove B-pillar sensor (3) from B-pillar.





Installation Note:
Establish correct positioning of B-pillar sensor (1) by means of guide pin (2) and screw (3).