Securing Engine In Installation Position

11 00 670 - Securing engine in installation position (M57T2)





Special tools required:
- 00 0 200
- 00 0 202
- 00 0 204
- 00 0 208
- 11 0 000
- 64 1 020






Warning!
Danger of injury!

Observe following instructions relating to special tool:

1. Prior to each use, check the special tools for defects, modifications and operational reliability.
2. Damaged/modified special tools must not be used!
3. No changes or modifications may be made to the special tools!
4. Keep special tools dry, clean and free of grease.





Necessary preliminary tasks:
- Secure engine bonnet/hood in service position Procedures
- Remove intake air manifold Service and Repair





Only on E92, E93:

Unclip two cover caps (1) on left and right of side panel screw connection with special tool 64 1 020.

Installation Note:
Replace damaged cover caps.





Assemble cross member 00 0 200 with special tools 00 0 202, 00 0 204, 00 0 208.





Important!
Avoid a change of engine position in the transverse or longitudinal direction.

Always make sure there is sufficient clearance between the engine (or its attachment parts) and the body.





Important!
Risk of damage!

With the aid of an assistant and the supports (1), place cross member 00 0 200 on the screw connections of the side panels.

Secure special tool 11 0 000 with the off-centre hole to spindle 00 0 202.

Attach suitable chains to special tool 11 0 000 and suspend from both engine suspension eyelets (2).





Warning!
Danger of injury!

Tighten down all adjusting screws and nuts on cross member 00 0 200.





Unscrew nuts (1).

Raise engine approx. 10 mm with cross member.

Installation Note:
Replace self-locking nuts.

Tightening torque 22 11 2AZ Specifications.

Check vacuum lines of engine mounts for correct position and connection.