Trunk / Liftgate Interior Trim Panel: Service and Repair
Trim Panel Replacement - Liftgate (Rendezvous)
Tools Required
J 38778 Door Trim Pad and Garnish Clip Remover
Removal Procedure
1. Raise the lift gate.
2. Remove the access trim panel from the lift gate.
3. Remove 2 screws from the bottom of the trim panel.
4. Use J 38778 to disengage the fasteners from the trim panel.
5. Remove the trim panel.
Installation Procedure
1. Install the trim panel to the lift gate.
Important: Discard the old trim panel fasteners. Install new fasteners.
2. Install new fasteners to the trim panel.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the screws to the bottom of the trim panel.
Tighten the screws to 2 N.m (18 lb in).
4. Install the access trim panel to the lift gate.
5. Close the lift gate.