D: Fuel Gage Accuracy Test

Open the Fuel Gage Sender connector and connect the two red clip leads of tester J-33431 to terminals E (BLK) and B (PPL) of the harness half of that connector. With Ignition in RUN. set the resistance dial on the tester to 0 ohms (E) and to 90 ohms (F). Observe the Fuel Gage (Fuel Gage will not respond instantly due to Anti-Slosh Device).

^ If the Gage responds correctly. install a new Fuel Gage Sender.

^ If the Gage does not respond correctly. check PPL (30) and BLK (151) wires for high resistance. If all checks are OK, replace the Instrument Cluster (see Service and Repair).