J: Low Coolant Indicator Does Not Light

1 Of 2:

2 Of 2:

1. Put the Ignition Switch in RUN and observe the LOW COOLANT Indicator.

^ If the Indicator is on, go to Test 3 (Table 1, illustration).

^ If the Indicator is not on, go to Step 2.

2. With the Ignition Switch in RUN measure the voltage at C100, terminal D3 (Connected).

^ If battery voltage voltage is not measured check the YEL/BLK 68 (wire) and bulb for an open. If OK. replace the Instrument Cluster.

^ If battery voltage is present check the YEL/BLK (68) wire between C100 and the ECM for an open. If OK, replace the ECM.