Assist Handle Replacement (With Lamp)

Assist Handle Replacement (With Lamp)

Removal Procedure





Important: The assist handle retaining screws are located under the handle. Do not remove the roof rail lamp cover and remove its two screws. The retainers (1) for these screws will fall behind the headliner.


1. Pull the assist handle down to expose its screws.




2. Remove the two screws (2).
3. Disconnect the roof rail lamp electric connector.
4. Remove the assist handle from the vehicle.

Installation Procedure

1. Position the rear assist handle to the headliner.




2. Connect the roof rail lamp connector.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the assist handle screws (2).

Tighten the assist handle screws to 3 Nm (27 lb in).