B3055

Diagnostic Chart:

SCHEMATIC
Refer to Theft Deterrent System Schematic (PASS-Key III) schematic.

CIRCUIT DESCRIPTION
When an ignition key is inserted into the ignition lock cylinder, the transponder embedded in the head of the key is energized by the exciter coils surrounding the ignition lock cylinder. The energized transponder transmits a signal that contains its unique value, which is received by the VTD (Pass Key III (R)) Module. The VTD (Pass Key III (R)) Module then compares this value to a value stored in memory (learned key code). If the value is correct the VTD (Pass Key III (R) Module sends the enable password via the class 2 serial data circuit to the PCM.

CONDITIONS FOR RUNNING THE DTC
The ignition switch must be in RUN. The VTD (Pass key III (R)) Module cannot have DTC B1327 set as a current DTC.

CONDITIONS FOR SETTING THE DTC
If the code from the ignition key does not match one stored in memory, the VTD (Pass Key III (R)) Module sets this DTC. This code indicates the use of a key with a transponder that has not been learned by the VTD (Pass Key III (R)) Module. The vehicle considers this to be a theft attempt.

ACTION TAKEN WHEN THE DTC SETS
1. The VTD (Pass Key III�) Module sends a class 2 message containing a disable password to the PCM.
2. The vehicle will not start.
3. The VTD (Pass Key III�) Module sends a class 2 message to the instrument cluster to flash the SECURITY indicator.

CONDITIONS FOR CLEARING THE MIL/DTC
The VTD (Pass Key III (R)) Module clears the current status of the DTC when it senses a valid, memorized, key code from the ignition key (transponder).

TEST DESCRIPTION
The numbers below refer to the step numbers on the diagnostic table:
2. The key must be a Pass Key III (R) transponder key with an operating transponder for the system to work.
3. The only method to confirm whether the transponder in the key or the VTD (Pass Key III (R)) Module is malfunctioning is to try a alternative component in the system. The vehicle was delivered with four keys.
4. It is unlikely that more than one key will be defective. If all keys do not work, the VTD (Pass Key III (R)) Module must be malfunctioning.
5. If the vehicle has a malfunctioning VTD (Pass Key III (R)) Module that malfunctioned during an ignition cycle, the system will be "fail enabled" and the vehicle will start for all keys. In this case the code B3055 will remain set and be current for all keys.
7. If a new key must be tried, it must have the proper mechanical cut and the VTD (Pass Key III (R)) Module must "learn" the transponder value.
8. If only one key was available for the vehicle and the replacement key does not work, the VTD (Pass Key III (R)) Module must be malfunctioning.