C0660

DTC C0660





Circuit Description
The automatic level control adjusts the vehicle suspension ride height. The RIM determines the height of the vehicle based on the voltage from the automatic level control sensor. The RIM raises and lowers the rear of the vehicle in order to keep the vehicle level.

Conditions for Running the DTC
^ The RIM is powered up.
^ DTC B1327 is not set.

Conditions for Setting the DTC
The exhaust valve solenoid output is found to be Open or shorted to ground for 10 seconds.

Action Taken When the DTC Sets
The automatic level control will be inoperative.

Conditions for Clearing the DTC
When the RIM does not detect a failure during the self test.

Diagnostic Aids
^ Inspect for the addition of any aftermarket components.
^ Inspect all wiring carefully for chaff's and proper routing.

Test Description
The numbers below refer to the step numbers on the diagnostic table.
2. Listen for an audible click when the exhaust solenoid operates. Command both the ON and OFF states. Repeat the commands as necessary.
5. Tests if ground is constantly being applied to the solenoid.