Assist Handle Replacement - Rear

Assist Handle Replacement - Rear

Removal Procedure





1. Pull the assist handle (3) down to expose the retaining screw covers (2).
2. Lift the covers and remove the retaining screws (1).




3. Pull the handle and the bezel away from the headliner and disconnect the lamp electrical connector (3).
4. Remove the assist handle from the vehicle.



Installation Procedure





1. Position the assist handle by the headliner.
2. Connect the lamp electrical connector (3).





Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the assist handle retaining screws (1).

Tighten the screws to 3 N.m (27 lb in).

4. Close the screw covers (2) and return the handle to the upright position.