B0935

DTC B0935

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview)provides an overview of each diagnostic category.



DTC Descriptor
DTC B0935
- Compass Sensor Circuit Open




Diagnostic Fault Information






Circuit Description

The internal fault detection of the electronic compass module is handled by the instrument panel cluster (IPC). The compass information is sent to the IPC via 2 discreet inputs from the electronic compass module. The IPC displays compass information in the driver information center (DIC). The compass connection failure occurs when the electronic compass module is disconnected or the sensor circuit(s) is open.


Conditions for Running the DTC

The instrument panel cluster (IPC) monitors the analog input value once every ignition cycle at power up.


Conditions for Setting the DTC

The IPC detects that the electronic compass module is not connected or the electronic compass sensor circuits are open.


Action Taken When the DTC Sets

The DTC will be set and stored in non-volatile memory.


Conditions for Clearing the DTC

* The DTC will become history when a power cycle has been performed and the fault is not detected by the IPC.
* A history DTC will clear after 100 fault-free ignition cycles.



Reference Information
Schematic Reference

* Driver Information System Schematics (Driver Information System Schematics)
* Instrument Cluster Schematics (Instrument Cluster Schematics)

Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Driver Information Center (DIC) Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning)for Scan Tool Information


Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the electronic compass module.
2. Ignition OFF, test for less than 1.0 ohm of resistance between the ground circuit terminal 14 and ground.

• If greater than the specified value, test the ground circuit terminal 14 for an open/high resistance.

3. Ignition ON, verify that a test lamp illuminates when connected between the ignition 1 voltage circuit terminal 13 and the ground circuit terminal 14.

• If the test lamp does not illuminate, test the ignition 1 voltage circuit terminal 13 for a short to ground or an open/high resistance.

4. Ignition OFF, disconnect the harness connector at the IPC.
5. Ignition OFF, test for less than 1 ohm of resistance between the compass sensor feed terminal 12 and 19.

• If greater than the specified value, test the compass sensor feed for an open/high resistance.

6. Ignition OFF, test for less than 1 ohm of resistance between the compass sensor return terminal 11 and 18.

• If greater than the specified value, test the compass sensor feed for an open/high resistance.

7. If all circuits test normal, test or replace the electronic compass module.



Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Electronic Compass Calibration (Programming and Relearning)
* Control Module References (Programming and Relearning) for the electronic compass module replacement, setup and programming