B1000

DTC B1000

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.



DTC Descriptors

DTC B1000 Electronic Control Unit (ECU) Performance


Circuit/System Description

The control module runs a program to detect an internal fault when power up is commanded.


Conditions for Running the DTC

Ignition ON.


Conditions for Setting the DTC

The control module has detected an internal malfunction.


Action Taken When the DTC Sets

The control module refuses all additional inputs.


Conditions for Clearing the DTC

* A current DTC clears when the malfunction is no longer present.
* A history DTC clears when the ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.



Circuit/System Verification

Verify that DTC B1000 is not set.

If the DTC is set, perform the setup procedure on the control module. If the DTC resets replace the control module.



Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.


Control Module References (Programming and Relearning) for control module replacement, setup, and programming