Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor Replacement

Removal Procedure





1. Disconnect the camshaft position (CMP) sensor electrical connector.




2. Remove the CMP sensor bolt (705).
3. Remove the CMP sensor (703).
4. Inspect the CMP sensor O-ring seal (704) for cuts or damage. If the seal is not cut or damaged, it may be reused.
5. Remove the CMP sensor O-ring seal (704), if necessary.



Installation Procedure





1. Lubricate the O-ring seal with clean engine oil.
2. Install the O-ring seal (704) onto the CMP sensor, if necessary.
3. Install the CMP sensor (703).

Notice: Refer to Fastener Notice (Fastener Notice).

4. Remove the CMP sensor bolt (705).

Tighten the bolt to 12 N.m (106 lb in).





5. Connect the CMP sensor electrical connector.