Inflatable Restraint Side Impact Sensor Replacement

Inflatable Restraint Side Impact Sensor Replacement

Removal Procedure






Caution: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

Caution: Refer to SIR Caution (SIR Caution).
1. Disable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair).
2. Place the window in the raised position to access the sensor.
3. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement (Service and Repair).
4. Remove enough of the water deflector to access the side impact sensor (1).
5. Loosen the bolts (2) on the inflatable restraint side impact sensor (1).
6. Remove the inflatable restraint side impact sensor (1) out from the door (4).




7. Remove the connector position assurance (CPA) (3) from the side impact sensor connector (4).
8. Disconnect the side impact sensor connector (4).
9. Remove the sensor from the vehicle.



Installation Procedure

1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Position the inflatable restraint side impact sensor by the door.




3. Connect the side impact sensor connector (4).
4. Install the CPA (3) to the side impact sensor connector.
5. Install the side impact sensor (1) to the door (4).





Notice: Refer to Fastener Notice.

6. Tightening the side impact sensor bolts (2).

Tighten the bolts to 10 N.m (89 lb in).

7. Install the water deflector to the door.
8. Enable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair).