Operation CHARM: Car repair manuals for everyone.

Front Brake Rotor Replacement




Front Brake Rotor Replacement

Special Tools
* CH-41013 - Rotor Resurfacing Kit
* CH-42450-A - Wheel Hub Resurfacing Kit

For equivalent regional tools, refer to Special Tools (Tools and Equipment).

Removal Procedure
Warning: Refer to Brake Dust Warning (Brake Dust Warning).


1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).





Note: Do not reuse the brake caliper bracket bolts.

3. Remove and discard the brake caliper bracket bolts (1).

Caution: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

4. Remove the brake caliper and bracket as an assembly and support with heavy mechanics wire or equivalent.




5. Remove the brake rotor bolt (1).




6. Remove the brake rotor (1).

Installation Procedure

1. If installing a new brake rotor, clean the friction surfaces of the brake rotor with denatured alcohol.
2. Using the CH-42450-A - Wheel Hub Resurfacing Kit , thoroughly clean any rust or corrosion from the mating surface of the hub/axle flange.
3. Using the CH-41013 - Rotor Resurfacing Kit , thoroughly clean any rust or corrosion from the mating surface of the rotor to the hub/axle flange.




4. Install the brake rotor (1).





Caution: Refer to Fastener Caution (Fastener Caution).

5. Install the brake rotor bolt (1) and tighten to 7 Nm (62 lb in).




6. Position the brake caliper and bracket assembly to the steering knuckle.
7. Install new brake caliper bracket bolts (1) and tighten to 150 Nm (111 lb ft) +45 degrees + 15 degrees.
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).
9. Burnish the brake pads and rotors. Refer to Brake Pad and Rotor Burnishing (Procedures).