P0335

Schematic:

CIRCUIT DESCRIPTION
The Crankshaft Position (CKP) sensor works in conjunction with a 58 tooth reluctor wheel on the crankshaft. The Engine Control Module (ECM) monitors the voltage between the CKP sensor signal circuits. As each reluctor wheel tooth rotates past the sensor, the sensor creates an analog signal. This analog signal is processed by the ECM. The reluctor wheel teeth are 6 degrees apart. Having only 58 teeth leaves a 12 degree span that is uncut. This creates a signature pattern that enables the ECM to determine the crankshaft position. The ECM can determine which two cylinders are approaching the top center based on the CKP signal alone. The Camshaft Position (CMP) sensor signal is used in order to determine which of the two cylinders is on a firing stroke. The ECM can then properly synchronize the ignition system, the fuel injectors, and the knock control. This sensor is also used in order to detect misfire. Refer to DTC P0300 for information on misfire detection. P0300

CONDITIONS FOR RUNNING THE DTC
The ECM has detected CMP sensor pulses.

CONDITIONS FOR SETTING THE DTC
The ECM has detected no CKP sensor pulses.

ACTION TAKEN WHEN THE DTC SETS
The ECM illuminates the Malfunction Indicator Lamp (MIL) and records the operating conditions in the Freeze Frame on the second consecutive drive trip that the diagnostic runs and fails.

CONDITIONS FOR CLEARING THE MIL/DTC
^ The ECM turns OFF the MIL after 3 consecutive drive trips that the diagnostic runs and passes.
^ A History DTC clears after forty consecutive warm-up cycles in which no failures are reported by this diagnostic or any other emissions related diagnostic.
^ The scan tool clears the MIL/DTC.

DIAGNOSTIC AIDS
Use the J 35616-A connector test adapter kit for any test that requires probing the ECM harness connector or a component harness connector. Using this kit prevents damage to the harness or component terminals. Refer to Using Connector Test Adapters in Diagrams. For an intermittent, refer to Symptoms. Symptom Related Diagnostic Procedures

Check for the following conditions:
^ The CKP shielded wiring for continuity or damage-By disconnecting the CKP sensor connector the shielded ground can be tested for continuity back to the ECM by connecting a test lamp to B+. Good CKP shield continuity will illuminate the test lamp.
^ Damaged harness-Inspect the wiring harness for any damage. If the harness appears to be OK, connect the DMM to the high and low signal inputs at the ECM connector. Monitor the resistance of the circuit while moving the harness in different locations. A fluctuation in the resistance will indicate the area of a possible concern.
^ Damaged CKP lead-If the sensor lead is damaged in any way the sensor must be replaced.
^ The CKP Sensor for proper installation-A CKP Sensor that is loose or not fully seated, causing an excessive air gap between the sensor and the reluctor wheel, may cause this DTC to set.

If a repair is necessary refer to Wiring Repairs or Connector Repairs in Diagrams.

TEST DESCRIPTION

Steps 1 - 8:

Steps 9 - 16:

The numbers below refer to the step numbers on the diagnostic table.
3. This step tests for proper CKP sensor resistance.
4. This step tests the CKP circuits for a short to ground. The DMM should indicate OL.
5. This step determines if the cause of the incorrect resistance is the sensor or the circuits.
6. This step tests for a short to voltage.
7. This step tests for proper CKP A/C voltage output at engine cranking speed.
8. This step determines if the cause of the incorrect resistance is the sensor or the circuits.