Assist Handle and Rear Coat Hook Replacement

Assist Handle and Rear Coat Hook Replacement

Removal Procedure




1. To remove the rear assist handle (2) and the coat hook, lifting the covers (1) that conceal the screws (3) (on at each end).
The rear assist handle (2) and the coat hook are removed as one.
2. Remove the screws (3) from the rear assist handle and the coat hook (2).
3. Remove the rear assist handle and the coat hook (2) from the upper rear quarter trim finish panel.

Installation Procedure




1. Install the rear assist handle and the coat hook (2) to the upper rear quarter trim finish panel.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the screws (3) to the rear assist handle and to the coat hook (2).

Tighten the rear assist handle and the coat hook screws to 1.5 Nm (13 lb in).

3. Close the rear assist handle and the coat hook covers (1) that conceal screws (3) (one at each end).