Knee Bolster Replacement - Driver (With UV2)

Driver Knee Bolster Replacement (UV2)

Removal Procedure

Important: The knee bolster trim panel must be replaced, not repaired, if there is any visible damage.







1. Remove the knee bolster trim panel by grasping at the top and the bottom and by pulling rearward.
2. Disconnect the night vision switch electrical connector (2).
3. Remove the knee bolster trim from the vehicle.



Installation Procedure

1. Connect the night vision switch electrical connector (2).




2. Align the knee bolster trim guide pins to the lower IP.
3. Push forward firmly in order to engage the clips onto the IP retainer.