P0573

DTC P0573

CIRCUIT DESCRIPTION
The electronic brake control module (EBCM) receives a signal from the brake pedal position (BPP) sensor through the brake position sensor signal circuit. The EBCM then applies a signal through the torque converter clutch (TCC)/brake/cruise control release switch signal circuit to the transmission control module (TCM) and engine control module (ECM).

CONDITIONS FOR RUNNING THE DTC
- The vehicle has cycled from 0-60 km/h (0-37 mph) 3 times in 1 ignition cycle.
- Continuous once the previous criteria have been met.

CONDITIONS FOR SETTING THE DTC
The TCM detects an open or short to ground on the stop lamp switch signal circuit when the voltage should be present.

ACTION TAKEN WHEN THE DTC SETS
- The TCM stores the DTC information into memory when the diagnostic runs and fails.
- The malfunction indicator lamp (MIL) will not illuminate.
- The TCM records the operating conditions at the time the diagnostic fails. The TCM stores this information in the Failure Records.

CONDITIONS FOR CLEARING THE DTC
- A last test failed, or current DTC, clears when the diagnostic runs and does not fail.
- A history DTC will clear after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
- Use a scan tool in order to clear the DTC.

TEST DESCRIPTION

Steps 1 - 6:

The number below refers to the step number on the diagnostic table.
2. This step determines if the fault is present.