P2544

DTC P2544

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.



DTC Descriptors
DTC P2544
- Transmission Torque Request Circuit




Circuit/System Description

To improve shift feel, the transmission control module (TCM) may request that the engine control module (ECM) reduce engine torque during shift events. When such a request is received, the ECM responds by retarding the injection timing and notifying the TCM that the request has succeeded. If the ECM is unable to comply with the request, the ECM sends the TCM a message that the request has failed.


The torque reduction request is sent to the ECM through GMLAN.


Conditions for Running the DTC

* The ignition is ON.
* The DTCs run continuously once the above condition is met.



Conditions for Setting the DTC

The ECM detects an invalid signal from the TCM for greater than 4 seconds.


Action Taken When the DTC Sets

DTC P2544 is a Type C DTC.


Conditions for Clearing the DTC

DTC P2544 is a Type C DTC.


Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Diagnostic Trouble Code Descriptions)


Circuit/System Verification

1. Observe the Freeze Frame/Failure Records with a scan tool.
2. Clear the DTCs with a scan tool.
3. Ignition OFF for 30 seconds.
4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.

• If DTC P2544 failed this ignition, replace the TCM.




Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.


Control Module References (Programming and Relearning) for TCM replacement, setup, and programming.