Stabilizer Shaft Link Replacement (FE1 and FE3)

Stabilizer Shaft Link Replacement (FE1 and FE3)

Removal Procedure





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
2. Remove the stabilizer shaft link bolt and nut.
3. Remove the stabilizer shaft spacer and insulators.



Installation Procedure






Notice: Refer to Fastener Notice .

1. Install the stabilizer shaft link insulators, spacer, nut and bolt.

Tighten the stabilizer shaft link nut to 15 N.m (11 lb ft).

2. Lower the vehicle.