Instrument Cluster Replacement

Instrument Cluster Replacement

Removal Procedure





Caution: Refer to Battery Disconnect Caution .
1. Disconnect the negative battery cable.
2. Remove the instrument panel (I/P) trim pad. Refer to Instrument Panel Trim Pad Replacement (Service and Repair) .
3. Carefully lift the head-up display (HUD) electrical harness from between the instrument panel cluster (IPC) and the HUD.
4. Disconnect the HUD electrical connector from the IPC.
5. Remove the IPC to steering column bracket retaining screws.
6. Raise the rear of the IPC slightly, then lift the IPC to access the electrical connector.
7. Disconnect the IPC electrical connector.
8. Remove the IPC.



Installation Procedure

1. Connect the IPC electrical connector.
2. Position the IPC to the steering column bracket.





Notice: Refer to Fastener Notice (Fastener Notice) .

3. Install the screws which retain the IPC to the steering column bracket.

Tighten the screws to 3 N.m (27 lb in).

4. Connect the HUD electrical connector to the IPC.
5. Install the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement (Service and Repair) .
6. Connect the negative battery cable.

Tighten the bolt to 15 N.m (11 lb ft).

7. Refer to Control Module References (Programming and Relearning) for programming and setup information.