Cabin Temperature Sensor / Switch: Service and Repair

Inside Air Temperature Sensor Replacement

Removal Procedure

1. Remove the knee bolster. Refer to Driver Knee Bolster Panel Replacement (Service and Repair) .
2. Remove the driver information center retaining screw.
3. Disconnect the driver information center from the I/P.
4. Disconnect the inside air temperature sensor from the driver information center bezel.




5. Disconnect the inside air temperature sensor electrical connector.



Installation Procedure

1. Connect the inside air temperature sensor electrical connector.

Important: Ensure that the inside temperature sensor is fully seated into the driver information center bezel.






2. Install the inside air temperature sensor.
3. Connect the driver information center to the I/P.

Notice: Refer to Fastener Notice .

4. Install the driver information center retaining screw.

Tighten the screw to 1.9 N.m (17 lb in).

5. Install the knee bolster. Refer to Driver Knee Bolster Panel Replacement (Service and Repair) .