Removal and Replacement

Remote CD Changer Replacement

Removal Procedure





1. Remove the cover from the I/P electrical center.
2. Remove the RDO/CD MiniFuse(R) #5 from the I/P electrical center.
3. Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Service and Repair) .
4. Remove the screws retaining the radio control to the I/P center support bracket.
5. Begin to remove the radio control from the center support bracket enough to access the connectors at rear of the radio control.
6. Disconnect the electrical/audio and coaxial cable connectors from the radio control.
7. Remove the radio control.
8. Remove the screws that retain the remote CD changer to the radio.
9. Disconnect the electrical lead from the radio to the CD changer and remove the changer from the vehicle.



Installation Procedure

1. Position the remote CD changer, with the shipping plug in the bottom position, to the radio and connect the electrical lead.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the retaining screws that secure the CD changer to the radio.

Tighten the screws to 2.5 N.m (22 lb in).

3. Remove the shipping plug from the bottom of the CD changer.
4. Connect the electrical/audio and coaxial cable connectors to the radio control.
5. Install the radio control into position in the I/P center support bracket.
Align the radio control locator tab into the center support bracket locator hole.




6. Install the radio control retaining screws.

Tighten the screws to 2.5 N.m (22 lb in).

7. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Service and Repair) .
8. Install the RDO/CD MiniFuse(R) #5 to the I/P electrical center.
9. Install the cover to the I/P electrical center.