Driver/Vehicle Information Display: Service and Repair
Driver Information Display Switch Replacement
Removal Procedure
1. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair) .
2. Remove the retaining screws from the bottom of the switch pad.
3. Pull outward to disengage the retaining clip.
4. Disconnect the electrical connectors.
5. Remove the retaining screws from the DIC switch.
6. Remove the DIC switch.
Installation Procedure
1. Install the DIC switch to the IP cluster bezel.
Notice: Refer to Fastener Notice (Fastener Notice) .
2. Install the DIC switch retaining screws.
Tighten the screws to 1.5 N.m (13 lb in).
3. Connect the DIC switch electrical connector.
4. Install the retaining screw at the bottom of the DIC switch pad.
Tighten the screw to 1.5 N.m (13 lb in).
5. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair) .