Head Up Display Switch Replacement

Head Up Display Switch Replacement

Removal Procedure





1. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair) .
2. Remove the retaining screw from the I/P dimmer/head-up display (HUD) switch assembly.
3. Disconnect the HUD electrical connector.
4. Remove the screws with secure the retaining switch to the bezel.



Installation Procedure





1. Install the HUD switch to the I/P cluster bezel.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the HUD switch retaining screws.

Tighten the screws to 1.5 N.m (13 lb in).

3. Connect the I/P dimmer/HUD switch electrical connector.
4. Install the HUD switch assembly to the I/P.

Tighten the screws to 1.5 N.m (13 lb in).

5. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair) .