Operation CHARM: Car repair manuals for everyone.

Exhaust Manifold Heat Shield Replacement - Right Side




Exhaust Manifold Heat Shield Replacement - Right Side (V8 and LHD) (4.6L, 4.4L SC)

Removal Procedure
Warning: Refer to Exhaust Service Warning (Service Precautions).

Warning: Refer to Protective Goggles and Glove Warning (Protective Goggles and Glove Warning).





1. Remove the generator assembly. Refer to Generator Replacement (LLT) (Generator Replacement)Generator Replacement (LH2 /AWD) (Generator Replacement)Generator Replacement (LH2) (Generator Replacement)Generator Replacement (LC3) (Generator Replacement).
2. Remove the exhaust system. Refer to Exhaust System Replacement (Service and Repair).
3. Disconnect the Bank 1, Sensor 1 oxygen sensor pigtail electrical connector from the wiring harness connector.
4. If the vehicle is equipped with all wheel drive (AWD), remove the right outer tie rod end from the steering knuckle to gain access to the exhaust manifold shield bolts. Refer to Steering Linkage Outer Tie Rod Replacement (Steering Linkage Outer Tie Rod Replacement).
5. Remove the bolts securing the engine wiring harness bracket to the right cylinder head.
Position the wiring harness bracket aside to aid in the removal of the exhaust manifold shield.
6. Remove the bolts securing the exhaust manifold heat shield to the exhaust manifold.
7. Reposition the exhaust manifold shield forward in vehicle in the area where the generator mounts, to gain access to the exhaust manifold bolts.
8. Remove the exhaust manifold from the vehicle. Refer to Exhaust Manifold Replacement - Right Side (LP1, LY7, LLT) (Exhaust Manifold Replacement - Right Side)Exhaust Manifold Replacement - Right Side (V8 and LHD) (Exhaust Manifold Replacement - Right Side).
9. Remove the heat shield from the vehicle.

Installation Procedure




1. Position the exhaust manifold shield to the vehicle, where the generator mounts, to allow for exhaust manifold installation.
2. Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (LP1, LY7, LLT) (Exhaust Manifold Replacement - Right Side)Exhaust Manifold Replacement - Right Side (V8 and LHD) (Exhaust Manifold Replacement - Right Side).
3. Install the exhaust manifold shield to the exhaust manifold.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the bolts securing the exhaust manifold heat shield to the exhaust manifold and tighten to 10 Nm (89 lb in).
5. Install the bolts securing the engine wiring harness bracket to the right cylinder head and tighten to 45 Nm (33 lb ft).
6. If previously removed, install the right outer tie rod end to the steering knuckle. Refer to Steering Linkage Outer Tie Rod Replacement (Steering Linkage Outer Tie Rod Replacement).
7. Connect the Bank 1, Sensor 1 oxygen sensor pigtail electrical connector to the wiring harness connector.
8. Install the exhaust system. Refer to Exhaust System Replacement (Service and Repair).
9. Install the generator assembly. Refer to Generator Replacement (LLT) (Generator Replacement)Generator Replacement (LH2 /AWD) (Generator Replacement)Generator Replacement (LH2) (Generator Replacement)Generator Replacement (LC3) (Generator Replacement).