Operation CHARM: Car repair manuals for everyone.

Head Up Display Switch Replacement




Head Up Display Switch Replacement

Removal Procedure




1. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).
2. Remove the retaining screw from the I/P dimmer/head-up display (HUD) switch assembly.
3. Disconnect the HUD electrical connector.
4. Remove the screws with secure the retaining switch to the bezel.

Installation Procedure




1. Install the HUD switch to the I/P cluster bezel.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the HUD switch retaining screws and tighten to 1.5 Nm (13 lb in).
3. Connect the I/P dimmer/HUD switch electrical connector.
4. Install the HUD switch assembly to the I/P and tighten to 1.5 Nm (13 lb in).
5. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).