Driver Seat Adjuster Replacement
Driver Seat Adjuster Replacement
Removal Procedure
1. Remove the seat. Refer to Driver or Passenger Seat Replacement (Driver or Passenger Seat Replacement).
2. Remove the seat cushion cover. Refer to Driver Seat Cushion Pad Replacement (Driver Seat Cushion Pad Replacement).
3. Reposition the lumbar pump, if equipped.
Remove the tie straps and reposition the pump and pouch up through the seat support wires.
4. Disconnect the seat belt harness from the seat frame.
5. Remove the memory seat control module.
6. Remove the bolts mounting the seat to the adjuster.
7. Remove the adjuster.
8. Transfer parts as necessary.
Installation Procedure
Caution: Refer to Fastener Caution (Fastener Caution).
1. Install the adjuster to the seat and tighten the bolts to 24 Nm (18 lb ft).
2. Install the lumbar pump, if equipped. Secure the pump to the torque tube with tie straps.
3. Connect the seat belt harness to the seat frame.
4. Install the memory seat control module.
5. Install the seat cushion cover. Refer to Driver Seat Cushion Pad Replacement (Driver Seat Cushion Pad Replacement).
6. Install the seat. Refer to Driver or Passenger Seat Replacement (Driver or Passenger Seat Replacement).
7. Calibrate the seat. Refer to Memory Seat Calibration (Programming and Relearning).