Passenger Seat Cushion Cover Replacement

Passenger Seat Cushion Cover Replacement

Removal Procedure

1. Remove the seat. Refer to Driver or Passenger Seat Replacement (Driver or Passenger Seat Replacement).




2. Remove the seat belt buckle and pretensioner from the seat frame.
3. Remove the passenger seat finish panel. Refer to Passenger Seat Outer Finish Panel Replacement (Passenger Seat Outer Finish Panel Replacement).
4. Remove the passenger seat rear panel bracket. Refer to Passenger Seat Rear Panel Bracket Replacement (Passenger Seat Rear Panel Bracket Replacement).




5. Remove the retaining clips which secure the cushion cover to the seat frame.
6. Remove the cover from the seat.

Installation Procedure




1. Position the trim cover over the seat cushion foam.
2. Install the cover to the seat frame.
3. Install the attaching retainers from the cover to the seat frame.
4. Install the rear flap ends together. Engage the hook and the loop.
5. Install the passenger seat rear panel bracket. Refer to Passenger Seat Rear Panel Bracket Replacement (Passenger Seat Rear Panel Bracket Replacement).
6. Install the passenger seat finish panel. Refer to Passenger Seat Outer Finish Panel Replacement (Passenger Seat Outer Finish Panel Replacement).





Caution: Refer to Fastener Caution (Fastener Caution).

7. Install the seat belt buckle and the pretensioner to the seat frame and tighten to 40 Nm (29 lb ft).
8. Install the seat. Refer to Driver or Passenger Seat Replacement (Driver or Passenger Seat Replacement).

Caution: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction.

9. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References (Programming and Relearning).