Fog/Driving Lamp Bulb: Service and Repair

Front Fog Lamp Bulb Replacement (XLR)

Removal Procedure

1. Remove the wheelhouse panel. Refer to Front Wheelhouse Liner Replacement (Service and Repair).
2. Disconnect the front fog lamp electrical connector from the fog lamp bulb/socket.





Warning

Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:

* Turn off the lamp switch and allow the bulb to cool before changing the bulb.
* Leave the lamp switch OFF until the bulb change is complete.
* Always wear eye protection when changing a halogen bulb.
* Handle the bulb only by its base. Avoid touching the glass.
* Keep dirt and moisture off the bulb.
* Properly dispose of the used bulb.
* Keep halogen bulbs out of the reach of children.

3. Remove the fog lamp bulb/socket from the fog lamp by rotating the bulb/socket counterclockwise (1).




4. Remove the fog lamp bulb/socket (1).

Installation Procedure




1. Install the bulb/socket (1) to the fog lamp.




2. Rotate the bulb/socket clockwise (1) until the bulb/socket is fully seated.
3. Connect the front fog lamp electrical connector to the fog lamp bulb/socket.
4. Inspect the fog lamp for proper operation.
5. Install the wheelhouse panel. Refer to Front Wheelhouse Liner Replacement (Service and Repair).
6. Aim the fog lamp. Refer to Fog Lamp Aiming (Procedures).