Electronic Suspension Front Position Sensor Replacement

Electronic Suspension Front Position Sensor Replacement

Removal Procedure

1. Turn OFF the ignition switch.
2. Raise the vehicle on a suitable safety stand. Refer to Lifting and Jacking the Vehicle (Service and Repair).
3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).




4. Disconnect the electronic suspension control (ESC) position sensor harness connector.




5. Remove the position sensor link from the control arm link stud.
6. Remove the position sensor mounting bolts.
7. Remove the position sensor from the vehicle.

Installation Procedure




1. Install the position sensor in the vehicle.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the position sensor mounting bolts and tighten to 3 Nm (26 lb in).
3. Install the position sensor link to the control arm link stud.




4. Connect the ESC position sensor harness connector.
5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).
6. Lower the vehicle.