Electronic Suspension Rear Position Sensor Replacement
Electronic Suspension Rear Position Sensor Replacement
Removal Procedure
1. Turn OFF the ignition switch.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).
4. Disconnect the electronic suspension control (ESC) position sensor harness connector.
5. Disconnect the position sensor link from the control arm link stud.
6. Remove the position sensor mounting bolt.
7. Remove the position sensor from the vehicle.
Installation Procedure
1. Install the position sensor to the vehicle.
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the position sensor mounting bolt and tighten to 7 Nm (62 lb in).
3. Connect the position sensor link to the control arm link stud.
4. Connect the ESC position harness connector.
5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).
6. Lower the vehicle.