Transmission Control Replacement

Transmission Control Replacement

Removal Procedure




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the intermediate exhaust pipe. Refer to Intermediate Pipe Replacement (Service and Repair).
3. Remove the floor panel tunnel panel reinforcement. Refer to Floor Panel Tunnel Panel Reinforcement Replacement (Service and Repair).
4. Disconnect the shift control cable from the floor shift control ball stud (3).
5. Lower the vehicle.




6. Remove the shift control trim plate. Refer to Console Trim Plate Replacement (Service and Repair).
7. Remove the center console assembly (1). Refer to Console Replacement (Service and Repair).
8. Remove the electrical connector from the shift control assembly.




9. Disconnect the wiring harness connector (1) from the shift lock control pigtail connector (2).




10. Remove the nuts (3) securing the shift control assembly (1) to the tunnel reinforcement.
11. Remove the shift control assembly from the tunnel reinforcement.

Installation Procedure




1. Install the shift control assembly (1) to the tunnel reinforcement.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the nuts securing the shift control assembly to the tunnel reinforcement and tighten to 12 Nm (106 lb in).
3. Connect the wiring harness connector to the shift lock control pigtail connector.




4. Install the electrical connector (1) to the shift control assembly.
5. Install the center console assembly. Refer to Console Replacement (Service and Repair).
6. Install the shift control trim plate. Refer to Console Trim Plate Replacement (Service and Repair).
7. Place the shifter in the NEUTRAL position.
8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




9. Connect the shift lock control cable to the ball stud (3). Refer to Transmission Control Replacement .
10. Install the floor panel tunnel panel reinforcement. Refer to Floor Panel Tunnel Panel Reinforcement Replacement (Service and Repair).
11. Install the intermediate exhaust pipe. Refer to Intermediate Pipe Replacement (Service and Repair).
12. With the shifter and the transmission in the NEUTRAL position, adjust the shifter cable. Refer to Shift Control Linkage Adjustment (Adjustments).
13. Lower the vehicle.