Fuel Injector Sight Shield Replacement

Fuel Injector Sight Shield Replacement

Removal Procedure




1. Grasp the intake manifold sight shield cover at the left side, lift up in order to disengage the cover from the ball stud.
2. Grasp the intake manifold sight shield cover at the right side, lift up in order to disengage the cover from the ball stud.
3. Remove the intake manifold sight shield cover from under the tab on the secondary air injection (AIR) check valve bracket.
4. Remove the intake manifold sight shield cover.




5. If necessary to remove the rear intake manifold sight shield perform the following steps, remove the AIR check valve. Refer to Secondary Air Injection Check Valve Replacement (Service and Repair).
6. Grasp the rear intake manifold sight shield cover and lift up in order to disengage the cover from the ball studs.
7. Remove the rear intake manifold sight shield cover.

Installation Procedure




1. If necessary to install the rear intake manifold sight shield perform the following steps, position the rear intake manifold sight shield cover over the ball studs.
2. Press down on the rear intake manifold sight shield cover over the balls stud in order to engage the cover to the ball studs.
3. Install the AIR check valve. Refer to Secondary Air Injection Check Valve Replacement (Service and Repair).




4. Install the intake manifold sight shield cover under the tab on the AIR check valve bracket.
5. Position the intake manifold sight shield cover over the ball studs.
6. Press down on the intake manifold sight shield cover over the balls stud in order to engage the cover to the ball studs.