Fuel Tank Pressure Sensor: Service and Repair

Fuel Tank Pressure Sensor Replacement

Removal Procedure




1. Remove the rear compartment liner. Refer to Rear Compartment Liner Replacement (Rear Compartment Liner Replacement).
2. Remove the fuel sender access hole cover bolts.
3. Remove the fuel sender access hole cover.




4. Disconnect the fuel level sensor wiring harness electrical connector (1) fuel tank pressure sensor.
5. Remove the fuel tank pressure sensor.

Installation Procedure





Note: Always use the NEW seal provided with the sensor.

1. Install the fuel tank pressure sensor.
2. Connect the fuel level sensor wiring harness electrical connector (1) to the fuel tank pressure sensor.




3. Place the fuel sender access hole cover into position.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the fuel sender access hole cover bolts.

Tighten the bolts to 2 Nm (18 lb in).

5. Install the rear compartment liner. Refer to Rear Compartment Liner Replacement (Rear Compartment Liner Replacement).