Electronic Suspension Front Position Sensor Replacement

Electronic Suspension Front Position Sensor Replacement

Removal Procedure




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the wheel from the vehicle. Refer to Tire and Wheel Removal and Installation (Service and Repair).
3. Disconnect the height sensor connector.
4. Disconnect the sensor link from the ball stud (1).
5. Loosen the sensor mounting nut.
6. Remove the sensor from the vehicle.

Installation Procedure




1. Insert head of the sensor mounting stud into the key hole.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Tighten the sensor mounting nut.

Tighten the nut to 9 Nm (80 lb in).

3. Connect the sensor link on the ball stud (1).
4. Connect the height sensor connector.
5. Install the wheel on the vehicle. Refer to Tire and Wheel Removal and Installation (Service and Repair).
6. Lower the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).