P0461
DTC P0461 (3.6L LY7)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0461
- Fuel Level Sensor 1 Performance
Diagnostic Fault Information
Circuit/System Description
The primary fuel level sender and the secondary fuel level sender changes resistance based on fuel level. The engine control module (ECM) monitors the signal circuits of the primary fuel level sender and the secondary fuel level sender in order to determine the fuel level. When the fuel tank is full, the resistances of both fuel level senders are low and the ECM senses a low signal voltage on both the signal circuits of the primary fuel level sender and the secondary fuel level sender. When the fuel tanks are empty, the resistances of the fuel level senders are high and the ECM senses a high signal voltage. The ECM uses the signal circuits of the primary fuel level sender and the secondary fuel level sender in order to calculate the percentage of remaining fuel in the tank. The ECM sends the fuel level percentage via serial data circuit to the instrument cluster in order to control the fuel gauge.
Conditions for Running the DTC
* The engine is running.
* No fuel level sensor signal failure present.
* Fuel level state is stable.
Conditions for Setting the DTC
* The ECM detects a difference between the engine consumed fuel and change of the fuel level signal of less than 1 L over a range of 30 L or 45.6 percent of the primary fuel tank.
* The above condition is present for greater than 300 seconds.
Action Taken When the DTC Sets
* The fuel gauge defaults to empty.
* The driver information center (DIC) displays the FUEL LEVEL LOW message.
* The ECM records the operating conditions at the time that the diagnostic test fails. The ECM displays the failure information in the Failure Records on the scan tool.
Conditions for Clearing the DTC
* The DTC becomes history when the conditions for setting the DTC are no longer present.
* The history DTC clears after 40 malfunction-free warm-up cycles.
Diagnostic Aids
A partially filled fuel tank and filling the fuel tank with the ignition ON or engine RUNNING may cause an inaccurate or erratic fuel gauge. This condition may cause a fuel system DTC to set and the fuel gauge to default to empty. Refer to Fuel Gauge Description and Operation (Fuel Gauge).
Reference Information
Schematic Reference
Instrument Cluster Schematics (Instrument Cluster Schematics)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Fuel Gauge Description and Operation (Fuel Gauge)
Electrical Information Reference
* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Component Testing
1. Ignition OFF, remove the fuel level sender and verify there are no obstructions interfering with the fuel level sender.
• If any interference is present, repair the fuel sender interference.
2. Ignition OFF, disconnect the harness connector at the fuel level sensor.
3. While sweeping the fuel level sensor through its full range of motion, test for a minimum resistance value of less than 41 ohms and a maximum value greater than 119 ohms between the signal terminal A and the low reference terminal D.
• If not within the specified range, replace the fuel level sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
* Primary Fuel Level Sensor Replacement (Service and Repair)
* Control Module References (Programming and Relearning) for the ECM replacement, setup, and programming