Operation CHARM: Car repair manuals for everyone.

Catalytic Converter Replacement - Right Side




Catalytic Converter Replacement - Right Side (LSA) (6.2L)

Removal Procedure
Warning: Refer to Exhaust Service Warning (Exhaust Service Warning).

Warning: Refer to Protective Goggles and Glove Warning (Protective Goggles and Glove Warning).


1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Support the exhaust with a suitable screw jack.




3. Disconnect the exhaust system from the left and right side catalytic converters. Refer to Exhaust System Replacement (LF1-Single) (Service and Repair)Exhaust System Replacement (LSA-Coupe) (Service and Repair)Exhaust System Replacement (LF1-Sedan/Wagon) (Service and Repair)Exhaust System Replacement (LLT-Coupe) (Service and Repair)Exhaust System Replacement (LLT-Sedan/Wagon) (Service and Repair)Exhaust System Replacement (LSA-Sedan/Wagon) (Service and Repair).
4. Using the screw jack, lower the exhaust system.
5. Disconnect the oxygen sensor electrical connectors.
6. Remove the right bank catalytic converter to exhaust manifold nuts.
7. Carefully remove the catalytic converter with the gasket (1) and oxygen sensors from the exhaust manifold.
8. Remove the oxygen sensors from the catalytic converter. Refer to Heated Oxygen Sensor Replacement - Bank 2 Sensor 1 (Heated Oxygen Sensor Replacement - Bank 2 Sensor 1) and Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 (Heated Oxygen Sensor Replacement - Bank 2 Sensor 2).

Installation Procedure

1. Install the oxygen sensors to the catalytic converter. Refer to Heated Oxygen Sensor Replacement - Bank 2 Sensor 1 (Heated Oxygen Sensor Replacement - Bank 2 Sensor 1) and Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 (Heated Oxygen Sensor Replacement - Bank 2 Sensor 2).




2. Install the catalytic converter gasket (1) to the catalytic converter.
3. Carefully install the catalytic converter to the exhaust manifold.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the catalytic converter nuts and tighten to 50 Nm (37 lb ft).
5. Tighten the catalytic converter to exhaust manifold nuts.
6. Connect the oxygen sensor electrical connectors.
7. Using the screw jack, raise the exhaust system.
8. Connect the exhaust system to the left and right side catalytic converters. Refer to Exhaust System Replacement (LF1-Single) (Service and Repair)Exhaust System Replacement (LSA-Coupe) (Service and Repair)Exhaust System Replacement (LF1-Sedan/Wagon) (Service and Repair)Exhaust System Replacement (LLT-Coupe) (Service and Repair)Exhaust System Replacement (LLT-Sedan/Wagon) (Service and Repair)Exhaust System Replacement (LSA-Sedan/Wagon) (Service and Repair).
9. Remove the screw jack.
10. Lower the vehicle.